Design Of Side Opening Type Gallbladder Opening Shoes

The design of the side opening type gallbladder shoes is the same as that of other opening shoes.

1. finished product drawing

As shown in figure 2-3-8, the side openings of this shoe are made of dark rubber band technology, and the front of the shoe gall is noted with a curved shape similar to that of Baotou.

2. structure design drawing

The shoe gall is connected with the shoe tongue, and the shoe tongue is decorated with flower sticks.

The structure design of side opening type gallbladder shoes is shown in figure 2-3-9.

First, the shoe tongue, side opening structure, dark rubber band, safety skin and other components are designed, and then the shoes and gallbladder parts are designed.

The design steps of the shoe gallbladder are the same as the whole tongue type gallbladder shoes.

The first step is to design the original shoe gall according to the pattern requirements of the finished product, and set the width of the shoe bladder Jo point on the front width line.

Connect JoO line to auxiliary line.

The line of shoes and gallbladder changes under the J00 line.

It extends forward into a curved arc and extends back into the whole tongue.

The shoe dash line and the original back middle curve form the original shoe gall, and the original shoe shoe is made as a duplicate board.

The length of the replica board can be taken to V'.

The second step: to make the back midline of the shoes and gallbladder parts to take the switch line and extend the EV line as the middle line of the back shoe.

The J2 point is found by intersecting the arc between the point and the midline.

The J2 point is the conversion length point, and the actual length should be found to determine the length difference.

And take the length difference of the 2 parts to fill the shoes and set the J3 point.

The third step: design the outline of the shoe bladder parts, and use the replica board to design the shoes and gallbladder parts in the straight line of the back.

First, the J point of the replica board is aligned with the J3 point on the back midline, and the Jo point is determined to ensure that the width of the shoe gallbladder remains unchanged.

Then draw the outline line of the shoe parts like the shoe covers, and the parts that are not long enough to be linked up.

The front section is painted in the shape of the copy board Baotou, and the length of the upper and lower lengths (AJ length and A'Jo length) are also equal.

Although the arc of the shoe gallbladder is quite different from that of the half girth, when the shoe is inserted, the shoes must rotate around the half round bar and have certain tensile deformation.

After the graphic design is completed, the difference between the inside and outside of the line and the outline of the shoe should be concentrated.

This processing method is like dealing with the shoe with cover, making only a difference between the concave arc.

Complete the design of decorative strip hole position.

Finally, the contour of the bottom rib and the difference between inside and outside are designed.