Basic Principle Of Shoe Last Design -- Knowledge Of Last Sticking

　　 Last sticking The materials include adhesive tape, transparent paper and kraft paper. Weigh the advantages and disadvantages and adopt Kraft paper Generally, the paper fiber is cut in a straight direction along the front and back of the last, with the length slightly exceeding the length of the last and the width slightly exceeding the width of the centerline of the last surface. The paper can be rubbed up without being cooked Last , but difficult to uncover and easy to distort. After rubbing, spread the paper flat, brush glue on the paper and last surface respectively, and wait for drying.

1. Full last sticker method

When the upper inlay is asymmetric (internal and external patterns are asymmetric), the whole last must be pasted. First cut 2/3 of the center line of the sticker, then align the center line of the sticker with the calling line at the front end of the shoe last and paste it on the surface of the last. Make two or three small cuts at the concave part of the last to make the last smooth.

2. Sticker method for half last surface

It is used for the style of symmetrical inlaying inside and outside the vamp. Method: Cut a piece of paper slightly longer than the shoe last, align it with the outer side of the shoe last, cut three notches at the concave part of the last, and then take a small piece of sticker to fill the three notches.

3. Full head, full heel, and empty waist file sticker method

For last pasting on sandal upper, two pieces of paper are generally cut according to the front upper length and the rear wing length, and pasted according to the size of the upper slightly more than the required size. If the upper is deep, cut it at the most concave part in the same way. If the upper is shallow, it is unnecessary to cut it.

4. Sticker method of short head, empty heel and full waist

It is used to stick the upper of female sandals to the last. Cut a piece of paper that is slightly shorter than the length of the last by 1cm, align the center line of the paper with the center line of the last, and stick it to the inner and outer rings of the last. If the head is empty, 1cm can be left, and a part of the lower mouth of the rear can be cut off to make the last stick more snugly.